댓글 0조회 수 54118추천 수 0
?

단축키

이전 문서

다음 문서

+ - Up Down Comment Print
?

단축키

이전 문서

다음 문서

+ - Up Down Comment Print

http://www.hindawi.com/journals/tswj/2014/731621/


The Scientific World Journal
Volume 2014 (2014), Article ID 731621, 8 pages
http://dx.doi.org/10.1155/2014/731621
Research Article

In-Line Ultrasonic Monitoring for Sediments Stuck on Inner Wall of a Polyvinyl Chloride Pipe

1Department of Mechanical Convergence Engineering, Hanyang University, Seoul 133-791, Republic of Korea
2School of Mechanical Engineering, Hanyang University, Seoul 133-791, Republic of Korea

Received 28 March 2014; Accepted 2 July 2014; Published 28 August 2014

Academic Editor: Ying Lei

Abstract

This research verified the applicability and effectiveness of the ultrasonic monitoring of sediments stuck on the inner wall of polyvinyl chloride (PVC) pipes. For identifying the transmittance of acoustic energy and the speed of sound in the PVC material, the pulse-echo ultrasonic testing was conducted for PVC sheets of different thicknesses. To simulate the solidified sediment, the hot melt adhesive (HMA) was covered on the inner wall of the PVC pipe in different heights. From the experiment, the speeds of sound in the PVC and the HMA materials were obtained as about 2258 and 2000 m/s, respectively. The thickness of the materials was calculated through the signal processing such as taking the absolute value and low pass filtering, the echo detection, and the measurement of the time of flight. The errors between actual and measured thicknesses of PVC sheets were below 5%. In the case of the substance stuck on the inner wall, the errors were below 2.5%. Since the pulse-echo ultrasonic inspection is available on the outer surface and its measurement accuracy was over 95%, it can be an efficient and effective in-service structural health monitoring for the sediment on the wall of PVC pipes.


분류 제목 조회 수
International Internal defect detection using laser-generated longitudinal waves in ablation regime     467
International Synthetic aperture imaging of contact acoustic nonlinearity to visualize the closing interfaces using tone-burst ultrasonic waves     684
Domestic Variation of Acoustoelastic Effect in Al6061-T6 according to Heat Treatment Time     653
International Dependence of Nonlinear Ultrasonic Characteristic on Second-Phase Precipitation in Heat-Treated Al 6061-T6 alloy     678
International Relative Measurement of the Acoustic Nonlinearity Parameter using Laser Detection of an Ultrasonic Wave  fileimage   8351
International A Method to Estimate the Absolute Ultrasonic Nonlinearity Parameter from Relative Measurements  fileimage   8491
International Finite element analysis of a low-velocity impact test for glass fiber-reinforced polypropylene composites considering mixed-mode interlaminar fracture toughness  fileimage   8478
International Assessment of Thermal Degradation by Cumulative Variation of Ultrasonic Nonlinear Parameter     47349
International Assessment of Thermal Aging of Aluminum Alloys by Acoustic Nonlinearity Measurement of Surface Acoustic Waves     44547
International Absolute Measurement and Relative Measurement of Ultrasonic Nonlinear Parameter     44760
International Experimental Comparison of Nonlinear Parameters Obtained from Absolute Measurement and Relative Measurement     43545
International Comparison of Ultrasonic Nonlinear Parameters Measured by PZT and LiNbO3 Transducers     44411
International Nanotribological and wetting performance of hierarchical patterns     44941
International Demonstration of Disturbance Propagation and Amplification in Car-Following Situation for Enhancement of Vehicle Platoon System     47522
International Relative Measurement of Acoustic Nonlinear Parameters and Comparison of Sensitivity to Thermal Aging     46449
International Non-contact Measurement of Elastic Modulus by using Laser Ultrasonic     49334
International Relationship between Second- and Third-order Acoustic Nonlinear Parameters in Relative Measurement     45310
International Non-Contact Evaluation of Acoustic Nonlinearity of a Laser-Generated Surface Wave in a Plastically Deformed Aluminum Alloy     45686
International Influence of repetitive pulsed laser irradiation on the surface characteristics of an aluminum alloy in the melting regime     46641
International Real-time detection of surface cracks on silicon wafers during laser beam irradiation     46250
Board Pagination ‹ Prev 1 2 3 4 5 6 7 8 9 Next ›
/ 9
Designed by hikaru100

나눔글꼴 설치 안내


이 PC에는 나눔글꼴이 설치되어 있지 않습니다.

이 사이트를 나눔글꼴로 보기 위해서는
나눔글꼴을 설치해야 합니다.

설치 취소

SketchBook5,스케치북5

SketchBook5,스케치북5

SketchBook5,스케치북5

SketchBook5,스케치북5

ISNDE Laboratory
203-2,Engineering Center Annex
Hanyang University,
222 Wangsimni-ro, Seongdong-gu
Seoul 04763, Korea
04763 서울특별시 성동구 왕십리로 222
한양대학교 공업센터 별관 203-2호
지능계측 및 비파괴평가 연구실
Tel: 02 - 2220 - 4220
Fax: 02 - 2299 - 7207