Absolute Measurement and Relative Measurement of Ultrasonic Nonlinear Parameter
http://www.tandfonline.com/doi/pdf/10.1080/09349847.2016.1174322
Absolute Measurement and Relative Measurement of Ultrasonic Nonlinear Parameters Jongbeom Kim a , Dong-Gi Song a , and Kyung-Young Jhang b a
Department of Mechanical Convergence Engineering, Hanyang University, Seoul, South Korea; b School of Mechanical Engineering, Hanyang University, Seoul, South Korea
ABSTRACT The ultrasonic nonlinear parameter is measured from the amplitudes of the harmonic frequency components generated during the propagation of ultrasonic waves in a material. There are two definitions for this parameter: absolute and relative. The absolute parameter is defined by the displacement amplitude; however, it is difficult to measure because of the very small displacement amplitude of the harmonic components. Conversely, the relative parameter is defined by the amplitude of the detected signal, regardless of displacement. Many researchers use the relative parameter because it is easier to measure, although it is only available for a relative comparison of different materials. However, it has not yet been verified that the ratio of the relative parameters between two materials is identical to that of the absolute parameters. In this study, we make it clear that the ratio of the relative parameters is inherently not identical to that of the absolute parameters, but that they can be identical to each other by compensating for material-dependent differences, such as detection-sensitivity and wavenumber. For verification, the absolute and relative parameters were measured for two different materials. The results showed that the ratios of absolute and relative parameters were in good agreement after compensation. KEYWORDS Al6061-T6; absolute parameter; fused silica; relative parameter; ultrasonic nonlinear p
-
Analysis of Transmitted Ultrasound signals through Apples at Different Storage Times using the Continuous Wavelet Transformation
-
Analysis of the influence of surface roughness on measurement of ultrasonic nonlinearity parameter using contact-type transducer
-
Air-coupled 트랜스듀서를 이용한 발전설비 배관에서의 유도초음파 모드 규명
-
Advanced Technologies for Estimation of Nonlinear Ultrasonic Parameter
-
Acoustic Nonlinearity of Narrowband Lager-generated Surface Waves in the Bending Fatigue of Al6061 alloy.
-
Acoustic Nonlinearity of a Laser-Generated Surface Wave in a Plastically Deformed Aluminum Alloy
-
Absolute Measurement and Relative Measurement of Ultrasonic Nonlinear Parameter
-
A6061 합금의 석출경화 열처리에 따른 탄성파의 음향 특성 연구
-
A Novel Method for Distance and Relative Velocity Measurement in Rear-End Collision Warning System
-
A nondestructive method for estimation of the fracture toughness of CrMoV rotor steels based on ultrasonic nonlinearity
-
A noncontact NDE method using a laser generated focused-Lamb wave with enhanced defect-detection ability and spation resolution
-
A Method to Estimate the Absolute Ultrasonic Nonlinearity Parameter from Relative Measurements
-
A lane-curve detection based on an LCF
-
"초음파의 비선형 특성을 이용한 SUS316L 재료의 피로열화 평가에 관한 연구 "
-
"차선의 회전 방향 인식을 위한 신경회로망 응용 화상처리"
-
"전기구동 특수차량의 제동 조향 성능 해석"
-
"음향 비선형 파라미터의 추정을 위한 바이스펙트럼 해석법의 적용"
-
"음속의 응력의존성을 이용한 재 료 상태평가에 대한 기초적 연구"
-
"웨이브렛 변환을 이용한 초음파 펄스 에코신호의 디컨볼루션"
-
"수박에서의 초음파 전파 특성에 관한 실험적 연구"