Assessment of Thermal Degradation by Cumulative Variation of Ultrasonic Nonlinear Parameter
http://link.springer.com/article/10.1007/s12541-017-0003-x
Assessment of thermal degradation by cumulative variation of ultrasonic nonlinear parameter
- Cite this article as:
- Kim, J. & Jhang, KY. Int. J. Precis. Eng. Manuf. (2017) 18: 23. doi:10.1007/s12541-017-0003-x
- 6Downloads
Abstract
The ultrasonic nonlinear parameter β has been studied for the evaluation of material degradation. However, there is a limit to the assessment of degradation induced by thermal aging in aluminum alloy because the nonlinear parameter may fluctuate with the aging time and thus it has not one-to-one correspondence with the thermal degradation. In order to overcome such limitation, we propose a cumulative nonlinear parameter βc defined by the accumulation of variation in the nonlinear parameter over the aging time. For verifying the usefulness of the proposed parameter, two kinds of aluminum alloy specimens heat-treated with different aging temperatures and aging times were tested. After the ultrasonic test has been completed, the tensile test was conducted for all specimens to measure the yield strength as a quantitative index of material degradation. Results showed that the nonlinear parameter β fluctuated in directions of both increase and decrease, while the strength decreased one-sidedly with the increase of aging time. On the other hand, the proposed parameter βc was one-sidedly increased, which showed strong exponential negative correlation with the yield strength. These tendencies were similar in different material and different aging temperature.
-
Dependence of Nonlinear Ultrasonic Characteristic on Second-Phase Precipitation in Heat-Treated Al 6061-T6 alloy
Date2018.11.28 CategoryInternational Views74279 -
Demonstration of Disturbance Propagation and Amplification in Car-Following Situation for Enhancement of Vehicle Platoon System
Date2015.09.16 CategoryInternational Views147728 -
Deep Learning-Based Ultrasonic Testing to Evaluate the Porosity of Additively Manufactured Parts with Rough Surfaces
Date2021.08.25 CategoryInternational Views21536 -
Cu와 Cu-Zn 합금의 저주기피로 동안 발달한 미세조직 평가를 위한 비파괴기술
Date2012.05.03 CategoryDomestic Views107716 -
CREEP CHARACTERIZATION OF SUPERALLOY IN-738 USING ULTRASONICC NONLINEARITY MEASUREMENT
Date2012.05.03 CategoryInternational Views115708 -
Crack Detection in Single-Crystalline Silicon Wafer Using Laser Generated Lamb Wave
Date2014.03.05 CategoryInternational Views139429 -
Compensation of a Second Harmonic Wave Included in an Incident Ultrasonic Wave for the Precise Measurement of the Acoustic Nonlinearity Parameter
Date2021.08.25 CategoryInternational Views45591 -
Comparisons of second- and third-order ultrasonic nonlinearity parameters measured using through-transmission and pulse-echo methods
Date2022.11.15 CategoryInternational Views2469 -
Comparison of Ultrasonic Nonlinear Parameters Measured by PZT and LiNbO3 Transducers
Date2017.01.16 CategoryInternational Views140270 -
Comparison of Linear and Nonlinear Ultrasonic Parameters in Characterizing Grain Size and Mechanical Properties of 304L Stainless Steel
Date2020.01.06 CategoryInternational Views31005 -
CHARACTERIZATION OF TAINLESS STEEL FIBER REINFORCED ALUMINUM COMPOSITE USING ULTRASONIC NONLINEARITY
Date2012.05.03 CategoryInternational Views127110 -
Calibration method using a narrowband signal for measurement of the acoustic nonlinearity parameter
Date2024.03.19 CategoryInternational Views39 -
Automatic Non-Contact Defect Inspection of Cylindrical Shell Using a Laser-Ultrasonic Technique
Date2012.05.03 CategoryInternational Views123560 -
Automatic Inspection of Pipe using Non-contact Guided-wave Technique with Enhanced Mode-selectivity
Date2012.05.03 CategoryInternational Views118032 -
Assessment of Thermal Degradation by Cumulative Variation of Ultrasonic Nonlinear Parameter
Date2017.01.16 CategoryInternational Views207870 -
Assessment of Thermal Aging of Aluminum Alloys by Acoustic Nonlinearity Measurement of Surface Acoustic Waves
Date2017.01.16 CategoryInternational Views124141 -
Application of the laser generated focused-Lamb wave for non-contact imaging of defects in plate
Date2012.05.03 CategoryInternational Views102634 -
Application of Nonlinear Ultrasonics to the NDE of Material Degradation
Date2012.05.03 CategoryInternational Views105007 -
Application of Macrofiber Composite for Smart Transducer of Lamb Wave Inspection
Date2014.03.05 CategoryInternational Views106250 -
Applicability of nonlinear ultrasonic technique to evaluation of thermally aged CF8M cast stainless steel
Date2021.08.25 CategoryInternational Views7011