Relationship between Second- and Third-order Acoustic Nonlinear Parameters in Relative Measurement
http://www.sciencedirect.com/science/article/pii/S0041624X14002947
Relationship between second- and third-order acoustic nonlinear parameters in relative measurement
Highlights
- •
We proposed the simplified form of third-order acoustic nonlinear parameter.
- •
We newly derived the relationship between simplified forms of second- and third-order nonlinear parameter.
- •
We experimentally verified this new relationship.
Abstract
The higher-order acoustic nonlinear parameters are considered effective damage indices in the field of nondestructive evaluation (NDE). They are defined by using the displacement amplitudes of the fundamental frequency and the harmonics, which are called the absolute nonlinear parameters. Generally, however, it is difficult to measure the very small displacement amplitudes of high-frequency harmonics. Therefore, the simplified parameters using the detected wave signal amplitudes, which are known as the relative nonlinear parameters, have been widely used, although their applications are limited to the relative comparison of before and after damage of a single material under consistent experimental circumstances. In this paper, in order to make clear the concept of relative parameter, we presented first that the relative ratio of the simplified parameters is identical to that of the absolute parameters when the detected signal amplitudes are linearly proportional to the actual displacement amplitudes with respect to the fundamental frequency and the harmonics. In addition, the new relationship between the relative ratio of simplified second-order parameter and the relative ratio of simplified third-order parameter was derived from the relationship between the absolute second- and third-order parameters. This new relationship was successfully verified based on experimental results obtained from Al 6061-T6 processed for different heat treatment times, where it was confirmed in advance that the PZT detection signal amplitudes at the fundamental frequency and its second- and third-order harmonics were linearly proportional to the displacement amplitudes.
-
Improvement of Crack Sizing Performance by using Nonlinear Ultrasonic Technique
-
Laser ultrasonic inspection in ablation regime
-
Influence of laser beam profiles on the frequency bandwidth of laser-generated surface acoustic waves
-
Study on the Nonlinear Electromagnetic Acoustic Resonance Method for the Evaluation of Hidden Damage in a Metallic Material
-
Measurement of Ultrasonic Nonlinear Parameter by Using Non-Contact Ultrasonic Receiver
-
High power CW laser-induced damage of CMOS image sensor
-
Real-time detection of surface cracks on silicon wafers during laser beam irradiation
-
Influence of repetitive pulsed laser irradiation on the surface characteristics of an aluminum alloy in the melting regime
-
Non-Contact Evaluation of Acoustic Nonlinearity of a Laser-Generated Surface Wave in a Plastically Deformed Aluminum Alloy
-
Relationship between Second- and Third-order Acoustic Nonlinear Parameters in Relative Measurement
-
Non-contact Measurement of Elastic Modulus by using Laser Ultrasonic
-
Relative Measurement of Acoustic Nonlinear Parameters and Comparison of Sensitivity to Thermal Aging
-
Demonstration of Disturbance Propagation and Amplification in Car-Following Situation for Enhancement of Vehicle Platoon System
-
Nanotribological and wetting performance of hierarchical patterns
-
Comparison of Ultrasonic Nonlinear Parameters Measured by PZT and LiNbO3 Transducers
-
Experimental Comparison of Nonlinear Parameters Obtained from Absolute Measurement and Relative Measurement
-
Absolute Measurement and Relative Measurement of Ultrasonic Nonlinear Parameter
-
Assessment of Thermal Aging of Aluminum Alloys by Acoustic Nonlinearity Measurement of Surface Acoustic Waves
-
Assessment of Thermal Degradation by Cumulative Variation of Ultrasonic Nonlinear Parameter
-
Finite element analysis of a low-velocity impact test for glass fiber-reinforced polypropylene composites considering mixed-mode interlaminar fracture toughness