Real-time detection of surface cracks on silicon wafers during laser beam irradiation
http://link.springer.com/article/10.1007/s12206-014-1206-z#page-1
Real-time detection of surface cracks on silicon wafers during laser beam irradiation
Abstract
In this paper, a real-time in situ method to detect surface crack initiation on silicon wafers during laser beam irradiation is proposed. This method collects scattered light from the silicon wafer surface subjected to the laser irradiation. When the crack is initiated, the laser beam is strongly scattered by the crack so that the proposed method can monitor the time of crack initiation based on the increases of the level of the scattering signal. In order to demonstrate the performance of this method, a silicon wafer specimen was illuminated by a continuous wave (CW) fiber laser beam (wavelength of 1,070 nm) and the scattered light was detected at three different laser powers. The scattering signal showed a very high level at the time of crack initiation. The detected crack initiation times were 11.6 s, 5.5 s, and 2.5 s at irradiances of 130 W/cm2, 149 W/cm2, and 168 W/cm2, respectively. These results agree well with the theoretical predictions. Based on these results, we demonstrated that the proposed method is very effective for the real-time in situ detection of surface cracking induced by laser beam irradiation on silicon wafers.
-
Fully Non-Contact Assessment of Acoustic Nonlinearity According to Plastic Deformation in Al6061 Alloy
-
"Acoustic Nonlinearity of Surface Wave in a Fatigued Aluminum Alloy Specimen "
-
Relationship between Second- and Third-order Acoustic Nonlinear Parameters in Relative Measurement
-
Crack Detection in Single-Crystalline Silicon Wafer Using Laser Generated Lamb Wave
-
2013 글로벌박사펠로우십 신규 사업 2 건 최종 선정 (박사과정 김진수, 석박통합과정 서호건)
-
인듐안티모나이드(InSb) 소자를 이용한 적외선 방사온도 계측시스템의 개발 연구
-
Comparison of Ultrasonic Nonlinear Parameters Measured by PZT and LiNbO3 Transducers
-
모드선택성을 강화한 비접촉식 유도초음파 기술
-
Single-mode guided wave technique using ring-arrayed laser beam for thin-tube inspection
-
Demonstration of Disturbance Propagation and Amplification in Car-Following Situation for Enhancement of Vehicle Platoon System
-
Fatigue-induced microdamage characterization of stainless steel 316L using innovative nonlinear acoustics
-
Non-Contact Evaluation of Acoustic Nonlinearity of a Laser-Generated Surface Wave in a Plastically Deformed Aluminum Alloy
-
Finite Difference Method Analysis of Ultrasonic Nonlinearity in Partially Degraded Material
-
Experimental Comparison of Nonlinear Parameters Obtained from Absolute Measurement and Relative Measurement
-
Non-contact Single-Mode Guided Wave Technique by the Combination of Wavelength-Matched Laser Generation and Angle-Matched Leak Wave Detection
-
Surface characteristics of aluminum 6061-T6 subjected to Nd:YAG pulsed-laser irradiation
-
Imaging of Harmonic Wave Generated by Contact Acoustic Nonlinearity in Obliquely Incident Ultrasonic Wave
-
Evaluation of Ultrasonic Nonlinear Characteristics in Heat-Treated Aluminum Alloy (Al-Mg-Si-Cu)
-
Assessment of Thermal Degradation by Cumulative Variation of Ultrasonic Nonlinear Parameter
-
Feasibility of MFC (Macro-Fiber Composite) Transducers for Guided Wave Technique
-
Non-contact Measurement of Elastic Modulus by using Laser Ultrasonic
-
Real-time detection of surface cracks on silicon wafers during laser beam irradiation
-
Influence of repetitive pulsed laser irradiation on the surface characteristics of an aluminum alloy in the melting regime
-
Absolute Measurement and Relative Measurement of Ultrasonic Nonlinear Parameter
-
Analysis of the influence of surface roughness on measurement of ultrasonic nonlinearity parameter using contact-type transducer
-
Thermal damages on the surface of a silicon wafer induced by a near-infrared laser