Absolute Measurement and Relative Measurement of Ultrasonic Nonlinear Parameter
http://www.tandfonline.com/doi/pdf/10.1080/09349847.2016.1174322
Absolute Measurement and Relative Measurement of Ultrasonic Nonlinear Parameters Jongbeom Kim a , Dong-Gi Song a , and Kyung-Young Jhang b a
Department of Mechanical Convergence Engineering, Hanyang University, Seoul, South Korea; b School of Mechanical Engineering, Hanyang University, Seoul, South Korea
ABSTRACT The ultrasonic nonlinear parameter is measured from the amplitudes of the harmonic frequency components generated during the propagation of ultrasonic waves in a material. There are two definitions for this parameter: absolute and relative. The absolute parameter is defined by the displacement amplitude; however, it is difficult to measure because of the very small displacement amplitude of the harmonic components. Conversely, the relative parameter is defined by the amplitude of the detected signal, regardless of displacement. Many researchers use the relative parameter because it is easier to measure, although it is only available for a relative comparison of different materials. However, it has not yet been verified that the ratio of the relative parameters between two materials is identical to that of the absolute parameters. In this study, we make it clear that the ratio of the relative parameters is inherently not identical to that of the absolute parameters, but that they can be identical to each other by compensating for material-dependent differences, such as detection-sensitivity and wavenumber. For verification, the absolute and relative parameters were measured for two different materials. The results showed that the ratios of absolute and relative parameters were in good agreement after compensation. KEYWORDS Al6061-T6; absolute parameter; fused silica; relative parameter; ultrasonic nonlinear p
-
Thermal damages on the surface of a silicon wafer induced by a near-infrared laser
-
Analysis of the influence of surface roughness on measurement of ultrasonic nonlinearity parameter using contact-type transducer
-
Absolute Measurement and Relative Measurement of Ultrasonic Nonlinear Parameter
-
Influence of repetitive pulsed laser irradiation on the surface characteristics of an aluminum alloy in the melting regime
-
Real-time detection of surface cracks on silicon wafers during laser beam irradiation
-
Non-contact Measurement of Elastic Modulus by using Laser Ultrasonic
-
Assessment of Thermal Degradation by Cumulative Variation of Ultrasonic Nonlinear Parameter
-
Evaluation of Ultrasonic Nonlinear Characteristics in Heat-Treated Aluminum Alloy (Al-Mg-Si-Cu)
-
Surface characteristics of aluminum 6061-T6 subjected to Nd:YAG pulsed-laser irradiation
-
Non-contact Single-Mode Guided Wave Technique by the Combination of Wavelength-Matched Laser Generation and Angle-Matched Leak Wave Detection
-
Experimental Comparison of Nonlinear Parameters Obtained from Absolute Measurement and Relative Measurement
-
Finite Difference Method Analysis of Ultrasonic Nonlinearity in Partially Degraded Material
-
Non-Contact Evaluation of Acoustic Nonlinearity of a Laser-Generated Surface Wave in a Plastically Deformed Aluminum Alloy
-
Fatigue-induced microdamage characterization of stainless steel 316L using innovative nonlinear acoustics
-
Demonstration of Disturbance Propagation and Amplification in Car-Following Situation for Enhancement of Vehicle Platoon System
-
Single-mode guided wave technique using ring-arrayed laser beam for thin-tube inspection
-
Comparison of Ultrasonic Nonlinear Parameters Measured by PZT and LiNbO3 Transducers
-
Crack Detection in Single-Crystalline Silicon Wafer Using Laser Generated Lamb Wave
-
Relationship between Second- and Third-order Acoustic Nonlinear Parameters in Relative Measurement
-
"Acoustic Nonlinearity of Surface Wave in a Fatigued Aluminum Alloy Specimen "